Why Do Some Enclosed 3D Printers Have Heated Chambers? What They Do, Who Needs One and When They Hurt
Published 6 November 2026. My own printers are open-frame (an A1 and an A2L), and this guide is built from
Published 6 November 2026. My own printers are open-frame (an A1 and an A2L), and this guide is built from
There is a number in your filament profile that quietly shapes half the problems people ask about. Rough top surfaces,
Warping is the oldest problem in FDM printing and it still catches people out, partly because the advice for it
I hit first layer rippling for the first time recently, and it took far longer to solve than it should
Skirt, brim and raft sit next to each other in the slicer’s settings and get lumped together as “adhesion helpers”,
Z-hop is one of those settings that gets switched on “just in case” and then forgotten, partly because the advice
The calibration routine post lists temperature as one of the early steps and moves on quickly. This post is the
Pull a print off the plate and the base flares outward slightly wider than the rest of the model —
Almost everything on this site about the first layer comes back to the same few levers: a clean plate, the
Pull a print off the plate and somewhere partway up, everything above a certain layer has shifted bodily to one
The first part of this series ended on a genuinely promising note: two BCMU units flashed with the AMS A
The general orientation post on this site covered why orientation matters across strength, surface finish, and print reliability all at