The Best 3D Printers for Beginners in 2026 — and Why Size Matters More Than You Think
Choosing a first 3D printer in 2026 is significantly easier than it was even two years ago. The calibration rituals, […]
Anycubic
Four Weeks With the Kobra X: Why I’m Sending It Back
The Kobra X is going back. I want to be very clear about what this post is and what it
Why Filament Profiles Matter More Than Most People Realise
Modern 3D printers have done something impressive and slightly deceptive at the same time: they have made the printing process
OrcaSlicer 2.4.0 Alpha Adds Kobra X Support — and That’s Not the Biggest News
OrcaSlicer dropped its 2.4.0 Alpha build on 25 May 2026 and the release notes make for genuinely interesting reading. The
Anycubic Kobra X — Week One: An A1 Owner’s Honest Assessment
One week in. The Kobra X has been on the desk beside the A1 since it arrived, and I have
Anycubic Kobra X: Unboxing, Setup, and First Print
As covered in the Kobra X editorial and the Kobra 4 vs Kobra X post, I have had the Kobra
CoreXY vs Bed Slinger: What the Theory Says, What Actually Happens
If you have spent any time researching 3D printers, you will have encountered the CoreXY versus bed slinger debate. It
Anycubic Kobra 4 vs Kobra X: Two Printers, One Confusing Lineup
Anycubic announced the Kobra 4 this week, and my first reaction was the same one I suspect a lot of
Anycubic Kobra X – My Next Printer?
I do not own the Anycubic Kobra X. I want to be clear about that from the start — this